Service Pack 1 for Synergy 2014 is available

Summery of fixes:

1. The number of animation frames can be set greater than 100 and the animation viewed. When you exit the dialog, the number of frames will revert to the default and must be set manually, each time.
2. On European operating systems, which use a comma as the decimal separator, the create mold block function now works as expected.
3. tcode reference help is available on European operating systems.
4. Temperature, internal mold around a part insert (3D) in BEM-Cool now displays as expected.
5. Vault client check-in, check-out and undo check-out are all enabled and work as intended.
6. Administrator restrictions with Autodesk Simulation Moldflow 2014 on Win 7 and Win 8 systems, has been addressed to enable access to users without administrator rights.
7. .stp files are read correctly into all relevant Autodesk packages.

Note: Point no. 6 will fix the issue of the article below:

"User can not start Autodesk® Simulation Moldflow® 2014 on Windows 7 without admin privileges"

How to get SP 1?

If you start Synergy an Auto update just pops up on the top right of the Synergy GUI: